Resistor programmable analog temperature sensor design
The LM57 uses a very small package of resistors (0.5mm & TImes; 1mm) that can be programmed to any 256 trip temperature and takes up very little board space. The VTEMP output can provide an analog output voltage with a negative temperature coefficient (NTC) that is proportional to the measured temperature.
The device's built-in temperature hysteresis (THYST) keeps the output stable (in a thermally oscillating environment). When the die temperature exceeds TTRIP, the digital temperature switch output will be activated and when the temperature is below TTRIP minus THYST, the digital temperature switch output will be released. One of the digital outputs, TOVER, is a highly active push-pull structure. For other digital outputs, TOVER is a low active open-drain configuration.
Figure 1 LM57 internal block diagram
If the TRIP-TEST input is high, the digital output will be active. A processor can read the logic levels of the temperature switch outputs to confirm that they are active. This allows for on-site verification, and the comparator and output circuits function properly after system assembly. When the TRIP-TEST pin is high, the trip level reference voltage appears on the VTEMP pin. The system can then use this voltage to more closely calibrate the accuracy of the sensor. Connecting TOVER to TRIP-TEST latches the output after the output is disconnected. It can be removed by forcibly depressing TRIP-TEST or by setting the LM57 to power down.
Table 1 List of LM57 program materials
Since the maximum current consumes only 28μA, the device has very low self-heating, about 0.02 ° C in still air.
Main features of LM57
• The open circuit temperature is set by an external resistor
• External resistors contribute to zero error
• Push-pull and open-drain temperature switch outputs
• Wide operating temperature, trip temperature range -50 ° C ~ 150 ° C
• Fully linear analog VTEMP temperature sensor output
• Short circuit protection analog and digital output
• TRIP-TEST pin allows testing in the system
• Digital output blocking function
• Ultra-small 2.5mm & TImes; 2.5mm 8-pin WSON package
Figure 2 Schematic diagram of the LM57 scheme
LM57 application
•Mobile phone
• Wireless transceiver
• Digital camera
• Personal Digital Assistant (PDA)
• Battery Management
•car
•Disk drive
•game
• Electrical appliances
LM57 program
The LM57EVM Evaluation Module (EVM) helps designers evaluate the operation and performance of the LM57. The LM57 is a high precision, dual output analog temperature sensor with integrated temperature switch. The user can set the open circuit temperature (TTRIP) through a programmable resistor. The LM57 can be programmed to any 256 trip temperature.
The EVM includes an LM57 resistor programmable temperature switch and an analog temperature sensor. It is pre-assembled with the LLP-8-10 LM57BISD and has a 10°C hysteresis with the LM57. Its head connector allows the user to expose all package leads for viewing and testing.
The multi-speed air supply mode can bring you a comfortable and cool breeze in various scenarios. The 180° wide-angle surrounds the healthy and refreshing natural wind, and the soft wind blows on the face, returning to the natural and refreshing. The fuselage is equipped with a lanyard, so you can take the wind with you anytime anywhere.
Neck Fan,Small Fan,Portable Mini Fan,Hanging Neck Fan
Guangdong Aiyimi Electronic Technology Co., Ltd. , https://www.seventreasuresfan.com